Shrink sleeving

Home › Forums › Fishing › Coarse And Match Fishing › Shrink sleeving

Viewing 1 reply thread
  • Author
    Posts
    • 23/04/2013 at 8:12 am #54901

      TF_JohnH

        I have cut a pair of universal top kits back to fit an old margin pole. I had to cut quite a bit off to get them to fit, removing all of the reinforced section at the female joint end.
        As is is for the edge I think I may need to reinforce the joint so need to know what is out there?
        I think the sort of sleeve I need is the type that everyone buys to convert a kit to a side pulled, reinforcing the wall for drilling.
        Any tips greatly recieved.

      • 23/04/2013 at 9:00 am #166628

        TF_sillysod

          Carbon mods pole repair kit

      • Author
        Posts
      Viewing 1 reply thread

      You must be logged in to reply to this topic.