daiwa square leg dimensions

[TF_BroomBroomParticipant]

does anyone know what the dimensions are of the legs off the old daiwa tournament pro box? more importantly are they the same size as fits the square leg milo boxes?

many thanks in advance

[TF_Fred Davis]

just measured mine and they are approx 19mm X 19mm now whether they call this a 20mm leg I don’t know but 19mm is what they are 😀 the box legs are longer than the platform legs the box legs are with mudfoot approx 49cm long 19 1/4 inches internale leg is 39mm with mudfoot does it fit the milo ? don’t know

[TF_Cutnut]

From memory the Daiwa legs are slightly smaller than the Milo, so accessories for the Milo will be fine on the Daiwa but not the other way around, and you may find yourself using a file on the fittings.

[TF_BroomBroomParticipant]

cheers for that gentleman, the daiwa side tray apparently fits both there round and square leg models and was wondering if it would fit on my milo, might have to get the drill and rivet gun out and have a play and see what i can muster up!

[TF_Cutnut]

I was able on some of the other makers square leg fittings to get them to fit by using a hot air gun on the Milo leg and heating it up so that the fittings ‘melted’ into place…not for the faint hearted. Some of the materials used are not easily softened this way so a good rasp or coarse file is needed. You might be able to swap out the fittings from your Milo or use the Preston fittings although they are rather bulky.

[TF_BroomBroomParticipant]

what i looked at was a preston long accessory bar, sits just shy of the middle leg if you place it on the rear one,and then getting a cut down piece of 25mm leg, could attach anything to that then, will have a think!

[Author]

Posts