Method moulds

[TF_AdzTParticipant]

Had problems yesterday with the groundbait sticking in the Preston method mould. First few came out fine then the problems started?

[TF_sumo]

What mix were you using ?

[TF_AdzTParticipant]

marukyu 120, I mixed it up on the bank, but I have problems with other mixes

[TF_sumo]

Do you double load , I have only had problems when the mix is drying out & I add groundbait to the initial load , Iv,e been using tghe sonubaits mix and never had a problem since as it mixes so well. If problems persist though just put a small bag over it and it should stop sticking

[TF_Oggy]

Try changing the consistancy of your mix to make it wetter or drier and see if that works or sprinkle a bit of dry groundbait in the mould before putting your method mix in.

[Stan]

Place a bit of plastic at the bottom of the mould before you add the GB it won’t stick then, I was using the Sonubait Tiger Fish Gb and mine wasn’t sticking

[TF_dirkdiggler]

why not have a look at the kobra flexi mould.
i reckon it’s better than the p i one.
and the feeders are better too.

[TF_Jabjab]

Not had a problem with the PI mould sticking.

There is a new one out from Drennan soon though…

[Anonymous]

add i tiny bit of dry gbait to mould befor use

[HOPEFULLParticipant]

I use the preston and had this problem also. Think someone on here told me to put the mould in a small plastic bag and then use as normal so the bag is between the g.bait/pellets and the mould. Works a treat and dead easy

[yorkiboy]

I wrap cling film around the mould if it starts to stick

[Author]

Posts